We run standing seam panels in 24 and 26 gauge, and which one to order is one of the questions we hear most. The short version: 24 gauge is thicker and stiffer and costs more. 26 gauge is lighter and costs less, and it holds up well on plenty of homes. The roof, the panel width and the spec decide which one makes sense.

How much thicker is 24 gauge?

Lower gauge numbers mean thicker steel. 24 gauge steel is about 0.024 inch thick, and 26 gauge is about 0.018 inch. That is roughly a third more steel in a 24 gauge panel. You notice it when you pick a panel up, and you see it in how flat a wide pan sits on the roof.

When we’d steer you to 24 gauge

Go with 24 gauge when the spec calls for it, which is most commercial work and anything with a manufacturer’s warranty tied to a specific panel. PAC-CLAD steel, for example, is 24 gauge.

We’d also pick 24 gauge for wide panels, long runs and open framing. A thicker panel shows less oil canning across a wide flat pan, and it is the panel to use where it spans between purlins instead of sitting on solid deck.

Finish is part of it too. Our Kynar 500 painted steel is 24 gauge and carries a 40-year paint warranty on Coated Metals Group coil. If the owner wants that finish, the gauge comes with it.

When 26 gauge is a good fit

On a house with solid decking, a narrower panel and no spec telling you otherwise, 26 gauge does the job and saves the owner money. Porches, sheds, barns and outbuildings are common places for it.

If you go with 26 on a wider panel, ask for striations or pencil ribs. They break up the flat pan and help hide oil canning.

What we run in each gauge

In 24 gauge we run Kynar 500 painted steel, AZ50 Galvalume, G90 galvanized and PAC-CLAD steel. In 26 gauge we run AZ50 Galvalume and SMP painted steel. More than 30 colors are on the chart across those finishes.

Trim follows the panels

Order trim in the same gauge and color as the panels so the finish matches and the flashing has the same stiffness as the roof around it. We bend trim from flat sheet in the same colors we run on the panel line.

Still deciding? Call Amy with the panel profile, the panel width and what’s under it, and she’ll tell you what we’d run. If you want to see a color in daylight before you commit, ask for a real steel sample. See all our profiles and finishes on the metal panels page.

Got a takeoff? We’ll run it.

We roll form standing seam panels and bend matching trim at our shop in Mt. Juliet. Most panel orders are ready in 1 to 2 days, for pickup or delivered to your site.

Call Amy: 615-961-8470Get a quote