PAC-CLAD panels, compared.
Five PAC-CLAD panels for roofs, walls and soffits. We roll form all five in our Mt. Juliet shop. Pick the seam that fits the job and call Amy.
What PAC-CLAD is
PAC-CLAD is the panel and coil line from Petersen, a Carlisle company. Their steel and aluminum carry a 70% PVDF (Kynar 500) finish with a 35-year non-prorated warranty, and more than 40 colors are stocked in 24 ga steel.
When a spec names PAC-CLAD, the panels, the flashings and often the underlayment all have to match. We bend those flashings from matching PAC-CLAD flat sheet, and our PAC-CLAD flashing details guide shows each one going on.
Metal Formers is a certified PAC-CLAD roll former. Product specs on these pages come from PAC-CLAD by Petersen and link back to PAC-CLAD’s own pages. PAC-CLAD, Tite-Loc, Tite-Loc Plus and Snap-Clad are trademarks of Petersen Aluminum Corporation.
Five PAC-CLAD panels, side by side
Seam height and lock decide most of it. The mechanically seamed Tite-Loc panels go down to a 1/2:12 slope. The snap-together panels need 2:12 or more and go on faster because there’s no seamer.
| Panel | Seam | Min slope | Best for |
|---|---|---|---|
| Tite-Loc | 2″, mechanical 90° | 1/2:12 | Commercial roofs, low slopes, open framing |
| Tite-Loc Plus | 2″, mechanical 180° | 1/2:12 | Low slopes, double lock specs, FM jobs |
| Snap-Clad | 1¾″, snap-together | 2:12 | Homes, light commercial, mansards |
| Q-150 | 1½″, snap-together | 2:12 | Homes and light commercial, long site runs |
| Flush Panel | 1″ deep, flush | Walls and soffits | Wall cladding, fascias, soffits |
Tite-Loc
Mechanically seamed to 90°. Structural, for low slopes and open framing.
Tite-Loc Plus
Double locked to 180°. For low slopes and double lock specs.
Snap-Clad
Snaps together with no seamer. Roofs, mansards and fascias.
Q-150
Low 1½″ snap seam for pitched architectural roofs.
Flush Panel
Flat 1″ panel for walls, fascias and soffits.
Watch PAC-CLAD panels go on
Install videos straight from PAC-CLAD. Each panel page has the videos for that panel.
Every install video is on PAC-CLAD’s YouTube channel.
PAC-CLAD through Metal Formers
We roll form all five panels in our Mt. Juliet shop from PAC-CLAD coil. Our New Tech SSQ II has a die for each PAC-CLAD profile on these pages, so your panels and matching flashings come from one shop.
We’re a certified PAC-CLAD roll former. We bend the flashings from PAC-CLAD flat sheet and coil, and we can make sample pieces for your crew to check on the roof before we run the rest.
We work in 24 ga PAC-CLAD steel and .032 and .040 aluminum. For long runs, we can also form panels right on your site, in as many trips as the job needs.
Call Amy at the shop
Tell us the panel, the gauge and the color, or send the spec section and we’ll sort it out with you. Call 615-961-8470.
615-961-8470